Product Overview
DTY-12R Features
2.0mm 7075 Aluminum main chassis
Super low CG design
Ultra strength pod design
Lightweight solid rear axle (spool)
Lightweight single clamp hubs
Rear pod down stop screw for easy setting
Easily adjustable rear spring
Easy to change rear ride height axle adjusters (kit contains 0.25, 0.50 ,0.75)
Delrin double disc dampers for equal damping control in all directions
Side springs above the chassis for easy to see adjustment
Super low Roll Centre rear pivot, Ball in a hole system for strength and super free motion.
Lipo brace using a band to hold Lipo in place for quick and easy access, no tape required.
Carbon Lipo battery stop
5mm pivot balls to spread the load of the rear end and offer the most support possible
Plastic side links for a super smooth pod motion.
Aluminium servo mount
New graphite front lower arm and plastic pivot
New plastic upper arm and steering knuckle
New 7075 aluminium front lower bulkhead. Short/long wheelbase +/-2.0mm adjustable
New 7075 aluminium caster block mount
New graphite front brace
Polished kingpin and upper hinge pin
Hard Anodised front pillow suspension balls, Silky smooth
High grade ball bearings
Check out the full write up from our friends at Red-RC : https://www.redrc.net/2024/01/destiny-dty-12r-112-competition-kit/
